UNROM to UOROM

UNROM to UOROM
Bend up eprom pins 1, 2, 24, 30, 31, and 32.
Bend up MC74HC32 pin 3.Can be left as is.
Solder pin 1 and 24 to hole 14.
Solder pin 2 to hole 22.
Solder pin 30 to MC74HC32 pin 3.
Solder pin 32 to hole 28.

I got this from looking at tokumaru pic of his uorom test cart. Worked for me.

Edit... some games wouldn't work in cart if 24 wasn't grounded.

Thanks! I'll add it to my list of conversions.

Some additional info, and then questions:

On a NES konami unrom board, the inputs for 7432 pin 3 (1Y) are
74161 Q3 (pin 11)
CPU A14 (cart edge pin 41)

On the TAITO-UNROM board used for Takeshi no Chousenjou, those two signals go to pins 4 and 5, 2A and 2B. So in that case it should be 2Y on pin 6 going to CHR A17.

And so the question: I'm trying to put the translated rom (http://www.romhacking.net/translations/1682/) on the original cart. I expanded and patched and test on a socketd NES cart and everything seemed ok. But I don't get anything after installed the eprom on the original board. Thoughts/ideas? Does this board do something else differently than the NES unrom board?
I'm assuming the prg layout is regular nintendo 128K prg, since it was a 28 pin mask rom.

wiring
pin 1 up
pin 2 -> hole 22 chr a16
pin 24 -> pin 16 gnd
pin 30 -> 7432 pin 6
pin 31+32 -> hole 28 5V