Exactly. CHR uses standard JEDEC pinout and can be swapped out one to one.
For PRG lift pin 1,2,24,30,31
This is for 27c010:
Pin 1 is VPP and should be tied to GND imo.
Pin 2 is connected to hole 24 (A16)
Pin 24 is connected to GND
Pin 30 is NC
Pin 31 is P (should be connected according to datasheet). GND should be fine.
I had cases where when I left P floating the EPROM wouldn't work. So make sure you read the datasheet for it.
Edited: 03/22/2018
at 03:02 PM
by Ice Man