So I've got everything ready to go for my first SNROM cart and I have a little bit of confusion. I have the original chip pulled from the board, and my new programmed chip with the new game is all ready to go. However, when looking at the instructions for the cart mod for the EPROM, I had some confusion, hopefully someone can clarify this.
So to my understanding, they're telling me to solder pin 2 to hole 24 which would make A16 hole 24 on the NES cart, and then solder pin 24 (which says OE on my pinout for my EPROM) to GND, which on my EPROM is pin 16. That is where the confusion came.
Am I actually supposed to solder on the EPROM chip itself from pin 24 to pin 16 (which is ground on this chip I'm using)?.
Here is the pinout:
I think that this would make sense, but if someone could just verify it would be very helpful. Still just getting the hang of this stuff!
Thanks,
-B
Quote:
SNROM (mapper 1):
Bend up pins 1, 2, 24, 30 and 31 (or cut tracks 2, 24 and 30)
Solder pin 2 to hole 24 (A16)
Solder pin 24 to GND (OE)
Solder pin 30 to hole 1 (A17)
Bend up pins 1, 2, 24, 30 and 31 (or cut tracks 2, 24 and 30)
Solder pin 2 to hole 24 (A16)
Solder pin 24 to GND (OE)
Solder pin 30 to hole 1 (A17)
So to my understanding, they're telling me to solder pin 2 to hole 24 which would make A16 hole 24 on the NES cart, and then solder pin 24 (which says OE on my pinout for my EPROM) to GND, which on my EPROM is pin 16. That is where the confusion came.
Am I actually supposed to solder on the EPROM chip itself from pin 24 to pin 16 (which is ground on this chip I'm using)?.
Here is the pinout:
I think that this would make sense, but if someone could just verify it would be very helpful. Still just getting the hang of this stuff!
Thanks,
-B