I have 2 power gloves(PG) and 2 sensor bars (SB). SB 1 works perfectly fine with PG 1 and PG 2. SB 2 does not work correctly with either PG 1 or PG 2. Just so we can eliminate the Power gloves themselves as being a problem or so I would like to assume.
On the SB 1 when turned on w/MTPO just the lower right led will flashes quick and then it's done all lights will be off and they will flash intermittently as buttons are used.
On the SB 2 when turned on w/MTPO all lights are steady solid and stay that way and automatically start the game and punches on it's own. However if no PG is plugged into the SB 2 no lights will be on and it does nothing. So there is something going on causing the SB 2 to malfunction soon as a PG is plugged into it.
I somewhat tried to clean the ultrasonic speakers... not really sure how, I wiped 2 of the 3 down with a q-tip and alcohol.
I swapped the amplifier chips from the working SB and vice versa, the chips are not the problem as both SB yielded same results.
I even sprayed deoxit into the controller port... yeah I'm reaching at this point haha.
I even did continuity on all wires to corresponding wires to make sure no wires were touching each other somehow. I did not do continuity to check for broken connections though.
Any help would be great. Thanks.
On the SB 1 when turned on w/MTPO just the lower right led will flashes quick and then it's done all lights will be off and they will flash intermittently as buttons are used.
On the SB 2 when turned on w/MTPO all lights are steady solid and stay that way and automatically start the game and punches on it's own. However if no PG is plugged into the SB 2 no lights will be on and it does nothing. So there is something going on causing the SB 2 to malfunction soon as a PG is plugged into it.
I somewhat tried to clean the ultrasonic speakers... not really sure how, I wiped 2 of the 3 down with a q-tip and alcohol.
I swapped the amplifier chips from the working SB and vice versa, the chips are not the problem as both SB yielded same results.
I even sprayed deoxit into the controller port... yeah I'm reaching at this point haha.
I even did continuity on all wires to corresponding wires to make sure no wires were touching each other somehow. I did not do continuity to check for broken connections though.
Any help would be great. Thanks.