I was planning purchasing some 64kb sram for my repro project... some HY6264A.
After looking at the datasheet I found out it have /cs2 on pin 26.
On the snes pcb this trace go to the reset pin (cart #26)
I never dealt with sram that have two /cs before.

My question is simple.. how will i wire the chip select circuit to the snes pcb?

Thanks

it's not /CS2, just CS2 (enabled when high). what have you been working with before that didn't have two enable lines?

after checking some datasheet, I realized its the same pinout as some other 64kb sram, so it will be compatible with donnor boards and aftermarket pcb...