http://nintendoage.com/forum/ -Sqooner http://nintendoage.com/forum/messageview.cfm?catid=22&threadid=171012 2017-02-06T21:57:48 -05.00 bluedanger 1 I have a donor cart Captain Skyhawk USA which is an AMROM board. For sake of testing and experience, I wanted to do a repro of Beetlejuice.
My question is, will I wire the AMROM board like an UNROM? I would ultimately like to use this board IF POSSIBLE to make Ghost n goblins, as I heard somewhere AMROM and UNROM are interchangable?

I have been reading quite a bit on repros, and screwed up my first one- wiring was good but i pulled a solderpad off the board for hole 22. 
I am using ST brand eprom M27C2001 and use famirom to fill up the extra space.

I cannot find much info regarding AMROM wiring, I am using 32 pin eproms and the donor board AMROM is a 28 pin PRG only, so I wont be removing any other chips.

Can someone please advise??

Thanks ]]>